SUNLU AMS dryer

Simultaneous Drying & Printing

By replacing the standard AMS cover, the AMS Heater enables active filament drying during printing—eliminating the need for an external dryer and reducing moisture-related print defects.

Fast, Uniform Heating

The PTC-based heater reaches a consistent 70 °C in about 20 minutes, thanks to a dual-airflow system that avoids hot spots and warping.

Smart Humidity Control

Equipped with humidity monitoring, the unit defaults to 55 °C in RH mode and runs for six hours. It automatically reactivates when humidity rises above 50 % and shuts off below 20 %. The user can also set a target humidity between 25–50 %.

Compact, Space-Saving Upgrade

The AMS Heater fits seamlessly atop the AMS with a simple “loosen–replace–tighten” installation process that takes only about two minutes. It supports up to 16 spools stacked, maintaining a compact build footprint.

Built-in Safety Features

Combining PTC heating, a thermostatic switch that trips if temperature exceeds 115 °C, and real-time software control of fan and heat, the system ensures safe and reliable operation.

Why It Matters

This upgrade saves both time and space by enabling drying directly in the AMS. It minimizes moisture-related print issues and is significantly cheaper than Bambu Lab’s AMS 2 Pro, making it an appealing aftermarket alternative